en:modellbau:kkmulticopterflashtool:arduinousblinker

Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

Link zu dieser Vergleichsansicht

en:modellbau:kkmulticopterflashtool:arduinousblinker [2020/11/01 16:40] (aktuell)
Zeile 1: Zeile 1:
 +====== How to make a ArduinoUSBLinker ======
 +The ArduinoUSBLinker is a project of LittleMo, for more information see the readme on [[https://github.com/c---/ArduinoUSBLinker#readme|github]].
  
 +To create a ArduinoUSBLinker you need an Arduino with on-board FTDI preferred. Before you can do anything plug it to your PC or Mac and check if it is recognized by the operating system. If not you may get a message to install a driver for the [[http://www.ftdichip.com/Drivers/VCP.htm|FTDI]] chip. When the driver is installed, go to the device manager and note down what port or device is associated to the Arduino when it is plugged to your computer.
 +
 +===== Step by step =====
 +You need a internet connection to load the firmware during the flashing.
 +
 +  * Make sure the Arduino is not plugged to the computer.
 +  * Start the kkflashtool, on Windows you have to select if you have a 32 or 64 bit OS.
 +  * go to the "Tools-->Upload ArduinoUSBLinker" menu.
 +  * Select the Arduino you like to use.
 +  * A dialog opens and asks you to plug your Arduino into your computer.
 +  * Wait 2-3 seconds until the Arduino is recognized by your computer.
 +  * Press okay.
 +  * A second dialog will tell you that a new device is discovered on port x.
 +  * Press okay.
 +  * The firmware will be downloaded from the internet and flashed to the Arduino.
 +  * When the magic message "Flashing of firmware was successfull." you are done.
 +
 +Don't forget to choose the ArduinoUSBLinker and enable the default baud rate again, before you update your bootloader enabled SimonK ESC.
 +===== Video =====
 +{{youtube>lNm7tqw_vCs}}
  • en/modellbau/kkmulticopterflashtool/arduinousblinker.txt
  • Zuletzt geändert: 2020/11/01 16:40
  • (Externe Bearbeitung)