Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- en:modellbau:kkmulticopterflashtool:arduinousblinker [2017/04/13 18:26]
+++ en:modellbau:kkmulticopterflashtool:arduinousblinker [2020/11/01 16:40] (aktuell)
@@ Zeile 1: / Zeile 1: @@
+====== How to make a ArduinoUSBLinker ======
+The ArduinoUSBLinker is a project of LittleMo, for more information see the readme on [[https://github.com/c---/ArduinoUSBLinker#readme|github]].
+To create a ArduinoUSBLinker you need an Arduino with on-board FTDI preferred. Before you can do anything plug it to your PC or Mac and check if it is recognized by the operating system. If not you may get a message to install a driver for the [[http://www.ftdichip.com/Drivers/VCP.htm|FTDI]] chip. When the driver is installed, go to the device manager and note down what port or device is associated to the Arduino when it is plugged to your computer.
+===== Step by step =====
+You need a internet connection to load the firmware during the flashing.
+  * Make sure the Arduino is not plugged to the computer.
+  * Start the kkflashtool, on Windows you have to select if you have a 32 or 64 bit OS.
+  * go to the "Tools-->Upload ArduinoUSBLinker" menu.
+  * Select the Arduino you like to use.
+  * A dialog opens and asks you to plug your Arduino into your computer.
+  * Wait 2-3 seconds until the Arduino is recognized by your computer.
+  * Press okay.
+  * A second dialog will tell you that a new device is discovered on port x.
+  * Press okay.
+  * The firmware will be downloaded from the internet and flashed to the Arduino.
+  * When the magic message "Flashing of firmware was successfull." you are done.
+Don't forget to choose the ArduinoUSBLinker and enable the default baud rate again, before you update your bootloader enabled SimonK ESC.
+===== Video =====
+{{youtube>lNm7tqw_vCs}}